Locksmith Kitchener 24-7 Unit
Locksmith Kitchener 24-7 Unit has years of knowledge and experience when it comes to any kind of make and type of door and lock. Call Locksmith Kitchener 24-7 Unit today for a fast help. Our Locksmith Kitchener 24-7 Unit is on call 24/7 and available right now!
A swing door guard adds an extra layer of safety between you; and the un-known outside your door. Much like door chain assemblies, swing door guards allow you; to open the door slightly without losing your sense of security. When you use a door chain assembly; an intruder can easily force his way into your home by snapping the chain with bolt-cutters.
Call us to check your doors!
The solid metal design of the swing door guards is harder to break and nearly impossible to cut. Install a swing door guard to keep you and your family safe. Measure the door a distance of 54 inches from the floor. Place a light pencil mark on the edge of the door near the opening. Place a torpedo level below the mark on the door. Use the level as a straight edge to make a line about 3 inches long. Extend the line horizontally onto the door jamb. Measure a distance of 3/8 inch from the edge of the door jamb and away from the door. Place a light mark at this location.
Position the bottom of the base attached to the large hinged loop side on the swing door guard on the horizontal line. Place the side of the base closest to the door on the 3/8-inch mark. Mark the screw holes opening in the base onto the door jamb. Create pilot holes at these marks with a 1/16-inch drill bit attached to a power drill. Place the base back onto the jamb.
Insert the screws provided with the swing door guard though the screw holes in the base and into the pilot holes. Attach a screwdriver bit to the power drill and drive the screws into the jamb, securing the looped side of the swing door guard on the door jamb. Measure a distance of 7/8 inch from the edge of the loop base onto the door. Place a light pencil mark on the door at the 7/8-inch distance.
Call us at any time to help!
Position the bottom of the base attached to the post side of the swing door guard along the horizontal line. Make sure the edge of the base lines up with the 7/8-inch mark you made on the door. Mark the screw hole openings on the door and create pilot holes with the 1/16-inch drill bit and power drill. Insert the screws through the holes in the base. Drive the screws into the door to secure the post side of the swing door guard to the back of the door.
Remember that our Locksmith Kitchener 24-7 Unit crew is a door service specialist and we are here for you 24/7. Call us now for any kind of door services!